DataKinetics DSC110 User Manual page 125

7.20.5 Maintenance Reset Circuit Initiate
MNRCI Maintenance Reset Circuit Initiate
This command is used to initiate a reset circuit to bring a circuit or a number of
circuits to idle.
MNRCI:CGRP=,[DEV=];
Syntax
MNRCI:CGRP=,[CIC=];
Prerequisites The item being reset is in service.
The circuits within a circuit group have been initiated.
The circuit group is not blocked or it's circuits inhibited.
A CIC can only be given for a network side group.
Attributes CONFIG,PROMPT
MNRCI:CGRP=33,DEV=3;
Example
MNRCI:CGRP=32,CIC=141;
7.20.6 Maintenance Restart System Initiate
MNRSI Maintenance Restart System Initiate
This command will restart the entire system. The current log-on session will be
terminated.
If a software update disk is present in the floppy disk drive then the software
update procedure will commence.
If no software update disk is present but a disk containing a configuration dump is
present then this configuration will be loaded into memory and the system will
restart.
In all other cases, no change to the system configuration will occur and the state
of all links will automatically be restored.
If RESET is set to Y then all configuration data will be removed.
None
Prerequisite
Syntax MNRSI:[RESET=Y];
Attributes PROMPT
Example MNRSI;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 125