DataKinetics DSC110 User Manual page 149

7.23.14 Routing Point of Origin End
RTPOE
Syntax
Prerequisites
Attributes
Example
DataKinetics DSC110 / DSC210 User Manual Issue 12
Routing Point of Origin End
This command is used to end a point of origin.
RTPOE:POR=;
The point of origin must already have been initiated.
There are no circuit groups using the point of origin.
If the point of origin is involved with circuit mapping then it can only be ended if
the circuit groups involved are blocked.
A point of origin cannot be ended if it is associated with a continuous record.
CONFIG
RTPOE:POR=1;
Page 149