DataKinetics DSC110 User Manual page 79

7.14.2 Access Side Signalling Link Change
ASSLC Access Side Signalling Link Change
This command is used to change the attributes of an Access Side signalling link.
Syntax ASSLC:ASLINK=,{[EQU=,][TS=,][END=,][ASTYPE=,][M56K=][L2K=];};
Prerequisites The specified link has already been initiated.
The specified PCM time slot is not already assigned elsewhere in the system.
The PCM on which the timeslot exists has been initiated.
The board on which the EQU exists has been initiated.
The timeslot is a valid timeslot number for the PCM type (up to 31 for an E1 PCM
and 24 for a T1 PCM).
The signalling processor specified by the EQU parameter must be equipped with a
valid board type and not already assigned to a link.
The signalling link must be blocked.
If the access type is Q931, NI2 or QSIG then the end must be N or U.
If the access type is DPNSS then the end must be A or B.
If M56K is set to a non zero value then all links on the same board for which M56K
is non zero must also use the same M56K value (i.e. Only one mode of 56kbits/s
operation is supported on any board at one time. However it is possible for some
links to operate at 64kbits/s whilst others operate at 56kbits/s).
Only EQU signalling processors 1 and 2 can be used.
Only M56K modes 1 and 2 can be used.
Attributes CONFIG
Example ASSLC:ASLINK=4,EQU=5-1,TS=5-1-16,END=U,ASTYPE=Q931-0;
7.14.3 Access Side Signalling Link End
ASSLE Access Side Signalling Link End
This command is used to end an Access Side signalling link.
Syntax ASSLE:ASLINK=;
Prerequisite No circuit groups are assigned to the signalling link.
The signalling link must be blocked.
The signalling link must not be monitored.
Attributes CONFIG
Example ASSLE:ASLINK=1;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 79