Signalling Card Hardware Settings (Rj45 Version) - DataKinetics DSC110 User Manual

6.3 Signalling Card Hardware Settings (RJ45 version)

J9
Figure 6.2 CS6 Card Link Positions (Cards with RJ45 connectors)
Jumper ID
J5
IRQ
J9
J10 (GO)
J11 (MON)
J19
J20
J29
MVIP/SCSA
(4 jumpers)
J50
LIU Selector
DataKinetics DSC110 / DSC210 User Manual Issue 12
MON
J11
SW1
J29
GO
J10
J5
IRQ
POSITION
not fitted
link fitted in position 15
This jumper position only exists on early revision
boards. Where the jumper exists it should be set
to position 128.
fitted
not fitted
fitted
fitted
fitted
Set to 'SCSA'
fitted in the 'top' position
For boards with RJ45 connectors the LIU
Selectors can be set to either the E1 120 ohm
position or the T1 position depending on whether
E1 or T1 operation is required. The selected
option is indicated by the post fitted to the main
board. The LIU selector nearest the top of the
st
board applies to the 1 LIU port. It is not
necessary to set both ports to the same type.
J19 J20
MVIP
SCSA
J50
RJ45
6 7
RJ45
LIU Selector
See Fig B.3
LIU Selector
See Fig B.3
Page 34