DataKinetics DSC110 User Manual page 92

7.16.13 Configuration PCM Initiate
CNPCI
Syntax
Prerequisites
Attributes
Example
7.16.14 Configuration PCM Change
CNPCC
Syntax
Prerequisites
Attributes
Example
DataKinetics DSC110 / DSC210 User Manual Issue 12
Configuration PCM Initiate
This command configures a PCM on a board such that it is available for
signalling or voice and optionally configures the PCM to be used as a potential
synchronisation source for the system. The command also allows the frame
format and line code to be configured.
CNPCI:PCM=,PCMTYPE=,[SYNCPRI=,][FF=,][LC=,];
The board on which the PCM exists has been initiated.
The PCM has not already been initiated.
The board has been blocked.
In hardware the board has been configured to the PCMTYPE selected.
For a PCMTYPE of E1 the LC may be set to HDB3.
For a PCMTYPE of T1 the LC may be set to AMI or B8ZS.
For a PCMTYPE of E1 the FF may be set to G704 or CRC4.
For a PCMTYPE of T1 the FF may be set to SF, ESF, CRC6, SLC96 or F4.
If the SIGTYPE on the board indicates Q931 then T1 cannot be specified and the
FF may only be set to CRC4.
CONFIG
CNPCI:PCM=5-1,PCMTYPE=E1,SYNCPRI=1;
Configuration PCM Change
This command allows changes to the configuration of a PCM.
CNPCC:PCM=,{[PCMTYPE=,]|[SYNCPRI=,][FF=,][LC=,]};
The PCM has already been initiated.
The board on which the PCM exists has been blocked.
In hardware the board has been configured to the PCMTYPE selected.
For a PCMTYPE of E1 the LC may be set to HDB3.
For a PCMTYPE of T1 the LC may be set to AMI or B8ZS.
For a PCMTYPE of E1 the FF may be set to G704 or CRC4.
For a PCMTYPE of T1 the FF may be set to SF, ESF, CRC6, SLC96 or F4.
If the SIGTYPE on the board indicates Q931 then T1 cannot be specified and the
FF may only be set to CRC4.
CONFIG
CNPCC:PCM=5-1,SYNCPRI=3;
Page 92