DataKinetics DSC110 User Manual page 113

7.18.5 CCS SS7 Route Initiate
C7RTI CCS SS7 Route Initiate
This command is used to configure an SS7 route to a destination point code. It
identifies which linkset should be used for traffic destined for the destination given.
Syntax C7RTI:C7RT=,DPC=,LS1=,[LS2=,][LSH=,][LABEL=,];
Prerequisites All SS7 signalling links must be blocked.
If specified, LS2 must have same SS7MODE, NI and OPC as LS1.
DPC must be different for each route.
The linkset specified has already been initiated.
Attributes CONFIG
Example C7RTI:C7RT=1,LS1=1,DPC=130,LABEL=ROUTE130;
7.18.6 CCS SS7 Route Change
C7RTC CCS SS7 Route Change
This command is used to change the attributes of an SS7 Route.
Syntax C7RTC:C7RT=,[DPC=,][LS1=,][LS2=,][LSH=,][LABEL=,];
If changing any parameter other than the LABEL then all SS7 signalling links must
Prerequisites
be blocked.
If changing the DPC then all circuit groups associated with the route should be
blocked.
If specified, LS2 must have same SS7MODE, NI and OPC as LS1.
If specified, LS1 must have same SS7MODE, NI and OPC as LS2.
The specified route has already been initiated.
Any linkset specified has already been initiated.
Attributes CONFIG
Example C7RTC:C7RT=1,LS1=2;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 113