DataKinetics DSC110 User Manual page 144

7.23.9 Routing Outgoing Route Change
RTORC Routing Outgoing Route Change
This command is used to change the data associated with a route
Syntax RTORC: OGR=,
Prerequisites The outgoing route has already been initiated.
The start moment must be greater than or equal to the number of called party
number delete digits.
If the route is involved in circuit mapping then no next route index can be given and
the hunt type or next route can only be changed if the circuit groups involved are
blocked.
ISM can only be set to a value other than 0 if ISC is set to Y by CNSYS command.
If specified the next route must already have been initiated.
If specified the routing chain that follows from the next route cannot eventually lead
to the outgoing route.
If specified the announcement must already have been initiated.
If an announcement is specified no next route index can be given.
If the local service mode is greater than 0 then the local service control table must
also be greater than 0. If the calling party number mode equals 0 then the local
service control table must also equal 0.
If specified the called party number and calling party number profiles must already
have been initiated.
N.B. When an outgoing circuit group from a route is Japan TTC ISUP and CG2PRE
is set the digits from the CG2PRE will form the carrier information code sent in the
IAM. The user should not set CGMD=2 when the route goes to an outgoing Japan
TTC ISUP circuit group.
Attributes CONFIG
Example RTORC:OGR=16,HUNT=1,CGMD=1,CGDL=5,CGPRE=01425;
DataKinetics DSC110 / DSC210 User Manual Issue 12
[HUNT=,][ANNC=,][CDST=,][CDDL=,][CDPRE=,][CGMD=,][CGDL=,]
[CGPRE=,][CPCD=,][CPCG=,][CG2PRE=,][CG2DL=,][LCMD=,]
[NEXT=,][CDMD=,][LSTAB=,][LSM=,][ISTAB=,][ISM=,][CHG=,]
[TANS=,][BWM=,][IBI=,][LABEL=,];
Page 144