Configuration - DataKinetics DSC110 User Manual

7.16 Configuration

7.16.1 Configuration Announcement Initiate
CNANI Configuration Announcement Initiate
This command is used to initiate an announcement on the converter. The
operation involves reading a announcement .WAV file data from a remote data
centre (if specified) or floppy disk and downloading it a board that can provide
announcements.
Valid file formats for announcements are:
CCITT A-Law 8.000 kHz, 8 Bit, Mono.
CCITT Mu-Law 8.000 kHz, 8 Bit, Mono.
The file name given should file name of the file without the suffix. The suffix is
.WAV for an ALAW or Mu Law encoded .WAV file.
Note: During execution of this command there may not be a response from the
system for up to 3 minutes while the command is being executed.
Prerequisites The RDC should be initiated and not blocked.
The ANNC cannot already be initiated.
Syntax CNANI:ANNC=,
[RDC=,
DIRECTORY=,]
FILE=,
[LABEL=,]
[REPEAT=,],
Attributes RDC,CONFIG
Example CNANI:ANNC=1,RDC=1,DIRECTORY=AUTH,FILE=EMERG,LABEL=EMERG;
7.16.2 Configuration Announcement Change
CNANC Configuration Announcement Change
This command is used to change data parameters associated with an
announcement on the converter.
Prerequisites The ANNC must already be initiated.
Syntax CNANC:ANNC=,
[LABEL=],
[REPEAT=,];
Attributes CONFIG
Example CNANC:ANNC=1,LABEL=EMERG,REPEAT=5;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 86