Circuit Assignment - DataKinetics DSC110 User Manual

7.15 Circuit Assignment

7.15.1 Circuit Assignment Circuit Group Initiate
CACGI Circuit Assignment Circuit Group Initiate
This command is used to initiate a Circuit Group.
If a PCM is specified then the group will use the PCM's timeslots for voice/data
traffic.
Syntax CACGI:CGRP=, POR=,{[ASLINK=],[C7RT=,BCIC=,NTTYPE=,]}
Prerequisites The CGRP value must not already have been assigned
If a PCM is specified it should already be initiated.
If assigning the group to a link (Access Side) the link must already be initiated and
blocked.
If assigning the group to a C7 Route (Network Side) the C7 Route must already be
initiated.
The point of origin must already be initiated.
PRI can only be entered for the Network Side or DPNSS on the Access Side.
NUP and TUP circuit groups cannot be assigned a C7 route that has ANSI linksets.
NUP circuit groups cannot be assigned a C7 route that has 24 bit point codes.
A circuit group cannot be initiated if a route from it is of hunt type circuit mapping
and its partner circuit group is unblocked.
COT cannot be set to a value other than zero except for TUP and ISUP.
Incoming COT check can only be set if there is a PCM present.
ENC can only be set if User to User Service 1 is set to Y.
TMRM can only be set to 2 if the circuit group is ISUP and is not ANSI.
Attributes CONFIG
Example CACGI:CGRP=1,PCM=5-1,C7RT=1,BCIC=241,NTTYPE=ISUP-2,POR=3,CC=1-4;
DataKinetics DSC110 / DSC210 User Manual Issue 12
[PCM=,][CPC=,][CC=,][POR=,][PRI=,][NTTYPE=,][L1=,][TMRM=,]
[INT=,][OHEC=,][IHEC=,][ENC=,][U2U=,][ISMD=,][COT=,][DCPC=,]
[DIV=,][TEXT=,] [SAT=,] [LABEL=,];
Page 81