7) The machine must be placed in a well ventilated area. It is important to make sure, however, that the machine is not near the air vent (for suction) of the room.

2.1.3 Before Starting the Work (230V)

iR2270 / iR2870 / iR3570 / iR4570

1-1 Points to Make Before Installation

Be sure to go through the following before starting the work:

1) If you are installing the machine after moving it from a cold to warm location, be sure to leave the machine unpacked for at least 2 hours so that the machine is

fully used to the site temperature, thus avoiding image faults caused by condensation. (The term "condensation" refers to the formation of droplets of water on

the surface of a metal object brought in from a cold to warm place, i.e., as the result of the rapid cooling of the moisture (vapor) around the object.)

2) The machine weighs a maximum of about 80 kg(including a DADF). Be sure to work in a group of 4 persons when lifting it.

1-2 Checking the Contents

Check to be sure that none of the following contents is missing:

100mm min.

1035mm

1178mm

182mm

1360mm

F-2-7

Chapter 2

0008-3400

2-3