Canon iR3570 Service Manual page 503

7) Push in the pin [1] through the hole [2] until it stops; then, connect the expansion delivery kit [3] to the right door [4].
Check to be sure that the joint pin is fully fitted as shown in the figure.
8) Using the self-tapping screw [1] you removed in step A-5), fix the joint plate [2] in place.
Check to be sure that the protrusion [3] of the joint plate is fully in the mounting hole.
10) Mount the right cover (rear) using 5 screws.
Take care not to trap the harness [1] by the cut-off [2] of the right cover (rear).
11) Close the right door.
12.4.4 Cleaning the Film Bias Static Eliminator
iR2270 / iR2870 / / iR2270N / / iR2870N / iR2230 / / / iR3530 /
A. Removing the Right Door
F-12-48
F-12-49
F-12-50
F-12-51
Chapter 12
0008-2928
12-19