12) After making sure that LED5 [3] (red) has gone on, set the bits of the DIP switch [1] (SW2) on the PCB as indicated in the table; then, press the push switch
[2] (SW4).
A press on the push switch [2] (SW4) will cause LED5 [3] (red) to go off, indicating that the RAM has been initialized.
13) Shift bit 6 of the DIP switch [1] (SW2-6) on the PCB to OFF.
14) Connect the telephone line to the controller.
If you are using the controller on its own, connect the modular jack cable to the connector [1] (LINE) of the controller.
If you are using the extension function, connect the existing telephone or fax to the connector [2] (TEL), and connect the telephone line to the connector [1]