Chapter 9
4) Free the AC harness [1] from the edge saddle [2].
5) Free the relay connector [1] of the signal cable from the connector holder
[2].
6) Disconnect the connector [2] from the relay connector [1].
7) Remove the fixing film unit [1].
9-24
F-9-128
F-9-129
F-9-130
F-9-131
F-9-132
9.5.5.8 Removing the Inside Delivery Sensor
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Disconnect the connector [2] of the harness [1].
2) Remove the front latch [2] of the inside delivery sensor [1]; then, detach
the inside delivery sensor.
9.5.6 Fixing Film Sensor
9.5.6.1 Removing the inside delivery cover unit (old)
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
The difference between new and old inside delivery cover unit:
Old inside delivery cover unit does not have a grip ring [1] at hinge. In this
case, detach the cover following the procedure below.
1) Remove the screw [1] and the stepped screw [2], and detach the inside
delivery cover unit [3].
F-9-133
F-9-134
[1]
F-9-135
0007-7932
0007-7895