Canon iR3570 Service Manual page 129

17) Plug the cable [1] in the terminal of voice board.
18) Plug the power cable (for receptacle) of the iR host machine into a receptacle.
19) Turn on the main power switch.
20) Check if the voice board has been recognized.
service mode
COPIER > DISPLAY > ACC-STS > PCI1
If 'voice guidance board' is indicated for PCI1, the board is correctly recognized by the machine.
3. Making Settings After Installation
To make use of the Voice Guidance Kit-A2 after turning on the host machine, you need to make the following settings in Additional Function:
Additional Function > System Setting > Voice Guide Manegement > Use Voice Guide.
1) Select [ON].
2) Press [OK].
default : OFF
4. Checking the Operation
- To Enable
1) Hold down the Reset key 3 sec or more.
2) See that the copy count on the screen is enclosed in red, indicating 'Voice Guidance' is ready for use.
- To Disable
1) Hold down the Reset key for 3 sec or more.
2.12.4 A point to keep in mind at installation
iR3025 / / iR3025N / iR3030 / / iR3030N / iR3035 / / iR3035N / iR3045 / / iR3045N
- In order to install this equipment, "Expansion Bus-B1" is required.
- In case of installing this equipment, "Voice Operation Kit-A1" cannot be installed.
2.12.5 Checking the Contents
iR3025 / / iR3025N / iR3030 / / iR3030N / iR3035 / / iR3035N / iR3045 / / iR3045N
<Voice Guidance Kit-B1>
[1]
[2]
F-2-185
[2] [1]
F-2-186
Chapter 2
0015-1981
0015-0859
2-55