Canon iR3570 Service Manual page 664

Chapter 16
DOC-REM
SIZE-DET
DATE-DSP
MB-CCV
TRY-STP
MF-LG-ST
CNT-DISP
PH-D-SEL
OP-SZ-DT
NW-SCAN
HDCR-DSP
JOB-INVL
LGSW-DSP
PCL-COPY
PRJOB-CP
16-38
COPIER > OPTION >USER
Sub-item
Setting whether or not to display the document removal message
<Setting range>
0: Do not display [Default 1]
1: Display
Turning the document size detection function ON or OFF
<Setting range>
0: OFF (When the platen is opened, the user will not be dazzled because the
lamp does not light.)
1: ON [Default]
Switching the date display format
<Setting range>
0: YYMM/DD
1: DD/MM/YY
2: MM/DD/YY
Limiting the mailbox control card user
<Setting range>
0: No [Default]
1: Yes
Setting output or no output in the tray full state
<Setting range>
0: Ordinary mode (Interrupt when the finisher tray is full) [Default]
1: Interrupt by height detection only
Setting the long mode key
<Setting range>
0: Ordinary [Default]
1: Display a long mode key on the corresponding mode screen
Setting whether or not to display a serial number when the counter confirmation
key is pressed
<Setting range>
0: Display a serial number [Default]
1: Do not display a serial number
Setting the number of lines for printing in Photo mode
<Setting range>
0: 141 lines [Default]
1: 134 lines
Turning document size detection in Book mode ON or OFF
Copying with the platen open is switched to the manual document size input
mode (conventional) or the automatic document size detection mode.
<Setting range>
0: Manual document size input mode [Default]
1: Automatic document size detection mode
Enabling or disabling the network scan function
<Setting range>
0: Network scan function disabled [Default]
1: Network scan function enabled
Notes:
Not changeable for anything in Japan
Always 1 for PSPCL outside Japan
Changeable for other outside Japan
Setting whether or not display HDD clearance in User mode and changing the
contents of clearance
<Setting range>
1: Clear once with 0 [Default]
2: Clear once with random data
3: Clear three times with random data
Setting the job interval at interrupt
<Setting range>
0: Output the next job continuously in interrupt copying (Standard) [Default]
1: Start outputting the next job after the last paper of the interrupted copy job is
output
2: Start outputting the next job after the last paper of all jobs is output
Setting whether or not to display [Log display ON/OFF] on the User mode
screen
<Setting range>
0: Do not display [Log display ON/OFF] [Default]
1: Display [Log display ON/OFF]
Supporting the PCL command [COPIES Meru/Pinatubo/Hood]
<Setting range>
0: Control each page according to the command of the COPIES command
specified to the page [Default]
1: Meru/Pinatubo/Hood compatible mode
2 to 65535: Reserved
Setting the CCV count pulse at reception and report output
<Setting range>
0: Do not output count pulse [Default]
1: Output count pulse
Description Level
1
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2