10.5.15 Fixing Driver Motor
10.5.15.1 Removing the Rear Cover
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Remove the 13 screws [1] and then the other screw [2]; then, detach the
rear cover [3].
If the left cover (lower) has already been detached, the screw [3] should also
have been removed.
[3]
[1]
[1]
[1]
[1]
[1]
[1]
[1]
10.5.15.2 Removing the DC Controller PCB
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Disconnect the connector [1].
F-10-228
[1]
[1]
[1]
[1]
[1]
[1]
[2]
F-10-229
0007-6403
How to Remove the Flexible Cable [1]
2) Remove the screw [1], and detach the DC controller PCB.
Points to Note When Replacing the DC Controller PCB
Be sure to remove the boot ROM [1] from the exiting DC controller PCB,
and mount it to the new DC controller PCB.
0007-6404
10.5.15.3 Removing the Fixing Drive Motor
iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
Chapter 10
F-10-230
F-10-231
F-10-232
F-10-233
0007-6405
10-45