Canon iR3570 Service Manual page 663

KSIZE-SW
<USER>
COPY-LIM
SLEEP
COUNTER1
COUNTER2to6
CONTROL
B4-L-CNT
COPY-JOB
PR-PSESW
IDPRN-SW
CNT-SW
REMPNL
BCNT-AST
Sub-item
Use it to enable/disable support of K paper.
<Setting range>
0: do not support K paper [Default]
1: support K paper
procedure
1) Set '0' in this service mode.
2) Set '0' for the following: COPIER > OPTION > BODY > MODEL-SZ.
3) Perform the shut-down sequence, and turn off and then on the main power.
Sub-item
Changing the upper limit of copy count
<Setting range>
1 to 9999 [Default: 999]
Turning the sleep function ON or OFF
<Setting range>
0: OFF
1: ON [Default]
The sleep function is set with Timer in User Mode.
Setting Software counter 1 on the User mode screen
<Setting value>
101: Total 1
[Value at shipping / Value after RAM clearance = 101 -> Cannot be changed]
Setting Software counters 2 to 6 on the User mode screen
<Setting range>
0 to 999
Limiting the user of a control card for a PDL job
<Setting range>
0: Do not use [Default]
1: Use
Setting whether to count B4 as the large size or the small size on Software
counters 1 to 6
<Setting range>
0: Small size [Default]
1: Large size
Prohibiting copy job reservation when a card reader and a coin robot are used
<Setting range>
0: Copy job reserved [Default]
1: Copy job not reserved
Setting whether or not to display the print pause function switch
<Setting range>
0: No print pause function [Default]
The user screen does not display the print pause function. (Conventional
specification)
1: Print pause function [Default]
The user screen does not display the print output stop and restart settings.
Switching the count-up job type about the department management counter
<Setting range>
0: Counting BoxPrint, ReportPrint, SendLocalPrint, and PDLPrint in the
PRINT category
1: Counting ReportPrint, SendLocalPrint, and PDLPrint in the PRINT category
Switching the charging counter and default display items
<Setting range>
- When the set value is 0 [Default]
101: Total 1
- When the set value is 1
102: Total 2
202: Copy total 2
127: Total A Total 2
- When the set value is 2
101: Total 1
104: Total small
103: Total large
501: Scan total 1
Turning the remote panel function ON or OFF
<Setting range>
0: OFF [Default]
1: ON
Switching the job type of counting box prints by ASSIST
<Setting range>
0: Count as PDL job [Default]
1: Count as Copy job
COPIER > OPTION > BODY
Description
T-16-52
COPIER > OPTION >USER
Description
Chapter 16
Level
2
Level
1
1
1
1
1
1
1
1
1
1
1
1
16-37