Removing The Right Cover (Rear); Removing The Right Door - Canon iR3570 Service Manual

Chapter 10
3) Open the 11 wire saddles [1], and pull out the harness [3] through the hole
[2] in the plate.
4) Remove the 3 screws [1], and detach the hopper assembly [2].
When fitting the hopper assembly to the machine, be sure that the connectors
[1] are securely connected. If the connectors [1] are not connected, the envi-
ronment heater will not be supplied with power, leading to image faults.

10.5.12.12 Removing the Right Cover (rear)

iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-
Y2)
10-38
F-10-178
F-10-179
F-10-180
F-10-181
2) Open the right lower door [2].
3) Remove the 5 screws [3], and detach the right cover (rear) [4].

10.5.12.13 Removing the Right Door

iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /
1) Open the right door.
2) Remove the screw [1], and detach the fixing plate [2].
3) Remove the joint shaft [1], and free the extension delivery unit [2] from
the right door.
0007-8412
4) Disconnect the connector [1], and remove the reuse band [2]; then, remove
the 2 screws (M4x8; RS tightening).
[4]
[2]
[1]
F-10-182
F-10-183
F-10-184
F-10-185
[3]
[3]
[3]
0007-8413