Installation Procedure; Before Starting The Work; Host Machine - Canon imagePASS-G1 Installation Procedure

1.2 Installation procedure

1.2.1 Before Starting the Work

Make sure the memory is added to 1024 MB in the iR
C6870/C5870.
RAM capacity can be checked with the procedure,
Service Mode > COPIER > Display > ACC-STS >
RAM.
Note: E604 will be displayed if the memory is not
added.
- Make the following selections in the host machine's
service mode, and set '3':COPIER>OPTION>
INT-FACE>IMG-CONT. (This way, the appropriate IP
address will automatically be setup for communica-
tion between the machine and its host machine.)
- Be sure that the back of the machine is at least 20cm
away from any wall as shown.
20 cm min.
1.2.2 Installing to the

Host Machine

1. Turning Off the Main Power
Turning Off the Main Power
When turning off the main power, be sure to go
through the following in strict sequence to protect the
machine's hard disk:
[1] Hold down on the power switch on the control
panel for 3 sec or more.
Machine
(rear)
Host machine
(front)
[2] Operate on the touch panel according to the shut-
down sequence indicated so that the main power
switch may be turned off.
[3] Turn off the main power switch.
[4] Disconnect the power cable (for the power outlet).
2. Setup procedure
1) Removed the cable from clamping.
- Clamp[1] 4 places.
- Connector[2] 1 piece.
[1]
2) Remove the rear cover(upper) [1].
-7 screws [2].
[1]
[2]
3) Remove the controller box cover [1].
-16 screws [2].
3
[2]
[2]