7) Shift bit 4 of the DIP switch [1] (SW2-4) found on the PCB of the controller to ON (so that the communication mode between the host machine and the controller
will be IPC).
8) If IC6 [1] is found on the PCB, shift bit 7 of the DIP swish [2] (SW2-7) to ON; otherwise, shift bit 7 of the DIP switch [2] (SW2-7) to OFF.
If IC6 [1] is not found, you need not mount any.
If you are mounting a ROM (IC6) [1] or replacing it for upgrading the connector, be sure to shift bit 7 of the DIP switch [2] (SW2-7) to ON.
9) Set the bits of the DIP switch [1] (SW3) on the PCB as indicated in the table.