Canon iR3570 Service Manual page 614

Chapter 15
Code
15-26
Detail code Name
E532 8001
Stapler shift error
(Finisher-S1)
8002
E532 0001
Stapler shift error
(Finisher-Q3/Q4)
0002
E535 0001
Swing cam error
(Finisher-S1)
0002
E535 0001
Swing cam error
(Finisher-Q3/Q4)
0002
E537 8001
Front alignment error
(Finisher-S1)
8002
E537 0001
Rear alignment error
(Finisher-Q3/Q4)
0002
E540 8002
Stack tray motor error
8003
(Finisher-S1)
Detection Remedy
The stapler slide home Replace the finisher controller
position sensor does not PCB. Replace the stapler shift
go on within 11 sec motor. Check the stapler shift home
when the stapler is position sensor. Check the harness.
shifted to home
position.
The stapler slide home
position sensor does not
go off within 1.0 sec
when the stapler is
shifted from home
position.
The home position Replace the finisher controller
sensor does not go off PCB. Replace the stapler shift
even after the stapler motor. Check the stapler shift home
shift motor has rotated position sensor. Check the harness.
for a specific period of
time.
The home position
sensor does not go on
even when the stapler
shift motor has rotated
for a specific period of
time.
The home position Replace the finisher controller
sensor does not go off PCB. Replace the swing cam motor.
within 1000 msec after Check the swing cam home position
the start of operation sensor. Check the harness.
when the swing arm is
shifted from home
position.
The home position
sensor does not go off
within 1.0 sec when the
stack delivery roller
swing arm is moved
from home position.
The home position Replace the finisher controller
sensor does not go off PCB. Replace the swing cam motor.
even when the swing Check the swing cam home position
motor has rotated for a sensor. Check the harness.
specific period of time.
The home position
sensor does not go on
even when the swing
motor has rotated for a
specific period of time.
The home position Replace the finisher controller
sensor does not go on PCB. Replace the front alignment
within 2.0 sec when the motor. Check the front aligning
front aligning plate is plate drive mechanism. Check the
moved to home front alignment home position
position. sensor.
The home position
sensor dos not go off
within 1.0 sec when the
front aligning plate is
shifted from home
position.
The home position Replace the finisher controller
sensor does not go on PCB. Replace the rear alignment
within 2000 msec after motor. Check the rear aligning plate
the start of operation drive mechanism. Check the rear
when the read aligning alignment home position sensor.
plate is moved to home
position.
The home position
sensor does not go off
within 1000 msec after
the start of operation
when the rear aligning
plate is moved form
home position.
Replace the finisher controller
The operation to detect
PCB. Replace the tray ascent/
the paper surface of the
descent motor. Check the stack tray
stack tray does not end
drive mechanism. Check the paper
within 1.0 sec.
surface sensor.
Replace the finisher controller
PCB. Check the stack tray upper
An abnormal
limit sensor. Check the stack tray
combination of sensor
lower limit sensor. Check the stack
states has been
tray upper paper surface sensor.
detected.
Check the stack tray lower paper
surface sensor.