Preparing The Slide Rail Assemblies - Silicon Graphics Origin 350 User Manual

Preparing the Slide Rail Assemblies

007-4566-001
Rackmounting Hardware (continued)
Table 1-3
Hardware Type
10-32 x 1/2-in. Phillips screw
Shoulder washer
Barnut
10-32 x 1/2-in. Phillips screw
Barnut
10-32 clip nut
10-32 x 1/2-in. Phillips screw
The slide rail assembly consists of a chassis rail and a slide rail. You need to remove the
chassis rail from the slide rail so that you can install a mounting bracket to the slide rail
and attach the chassis rail to the module (see "Preparing the Module" on page 30). To
remove the chassis rail from the slide rail, follow these steps:
1. Remove the two slide rail assemblies and the rear mounting brackets from the
shipping container.
2. Extend each slide rail assembly until the safety latch snaps into place.
3. Press the safety latch and remove the chassis rail from the slide rail, as shown in
Figure 1-12.
Installing the Server System in a Rack
Qty Usage
8 Secures the slide rails to the rack rails.
8
4
4 Secures the slide rails to their mounting brackets.
2
2 Provides a threaded hole for fastening the module front
panel to the rack rails.
2 Fastens the module front panel to the clip nut.
27