Silicon Graphics Origin 350 User Manual page 225

007-4566-001
10. Connect the L1 controller cable to the connector on the new L1 controller display,
making sure that the red stripe is to your left, as shown in Figure 6-34A.
11. Align the two screw holes on the L1 controller display with the holes on the L1
display protective cover, and screw in the two Phillips screws, as shown in
Figure 6-34B.
12. Hook in the L1 display protective cover onto the slots on the front chassis and,
holding the L1 display cover up against the front chassis, screw in the Phillips
screw, as shown in Figure 6-34C.
13. Replace the front bezel onto the front chassis of the system by screwing in the two
Phillips screws holding the bezel to the chassis, as shown in Figure 6-34D.
L1 Controller Display
199