Trailing Edge Sensor Removal; Media Present Sensor Flag Removal - Lexmark MS517dn Service Manual

Trailing edge sensor removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the rear door and cover. See
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Position the printer so that it sits on its left side.
8
Disconnect the cable JACM1 from the controller board.
9
Release the retainer spring (A) from the bracket (B).
10
Remove the screw (C).
Media present sensor flag removal
Note: For a video demonstration, see
1
Remove the toner cartridge, and then remove the imaging unit.
2
Remove the tray insert.
"Left cover removal" on page
"Right cover removal" on page
"Rear door and cover removal" on page
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
A
Media present sensor flag
Parts removal
228.
241.
289.
291.
B C
removal.
299
4514-6xx
307.
290.