Paper Remaining Sensor Removal; Belt Unit Drive Frame, Bud Motor, Bud Sensor Removal - Lexmark Optra Color 1200 Service Manual

Service manual
Hide thumbs Also See for Optra Color 1200:
Table of Contents

Advertisement

5050-001
Installation Notes:
1. After you replace the belt, do the transfer belt adjustments. Run
tests in the service mode. Enter the thermistor rank value and
adjust the print position (top margin K and C) in the service
mode. Check the belt tracking.
2. Check and adjust the printhead adjustments (X, Y and Theta
position) in the service mode, if necessary.

Paper Remaining Sensor Removal

1. Remove the belt unit.
2. Remove the connector and the sensor. The sensor is a snap-fit
type.
Belt Unit Drive Frame, BUD Motor, BUD Sensor
Removal
1. Remove the belt unit. Do not turn it upside down.
2. Remove the 3 screws and pull it from the front.
4-12
Service Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Optra Color 1200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents