Cleaning Brush Replacement - Ricoh A095 Service Manual

4.6 CLEANING BRUSH REPLACEMENT

[D]
1. Remove the cleaning blade. (Refer to Cleaning Blade Replacement.)
2. Remove the coupling gear [A] (1 screw).
3. Remove the grounding wire [B] (1 screw).
4. Remove the bushing [C].
5. Pull the cleaning brush shaft to the rear to release the cleaning brush [D],
then remove the cleaning brush.
NOTE: Do not touch the cleaning brush with oily hands.
After replacement, clean the ID sensor surface.
A095/A096/A097
[A]
5-54
[C]
[B]
FSM