Table of Contents
Advertisement
[B]
[A]
[E]
[D]
[F]
4. Remove the coupling gear [A] (1 screw).
NOTE: Be careful not to lose the pin [B].
5. Remove the gear [C] (1 E-ring), gear [D] (1 E-ring) and gear [E].
CAUTION: Do not touch the screws at [F] and [G].
If the screws at [F] are loosened, the doctor gap will be
improper.
If the screws at [G] are loosened, the photoconductor gap
and magnetic field angle will be improper.
If either of them become abnormal, toner density control
will be abnormal.
6. Remove the front roller holder [H] (1 screw and 2 E-rings) and rear roller
holder [I] (1 screw).
A095/A096/A097
[I]
[C]
5-44
[H]
[G]
FSM
Advertisement
Table of Contents
