Table of Contents
Advertisement
NOTE: 1) When installing the jogger fences, confirm if the two positioning
pins [A] are correctly set in the two holes on the side fences after
the screw is set.
2) When installing the positioning roller assembly, insert the plate [B]
in the hole [C] on the rear frame, then set the plate on the lever
[D].
3) When installing the rear paper press mylar, set the hook [E] to the
rear jogger fence [F] as shown so that the mylar moves together
with the jogger fence [F].
4) After installing the jogger fences, manually move the jogger
fences [F] to confirm that they move smoothly.
5) After re-assembling the duplex unit, manually pull the plungers of
the positioning roller solenoid and the pressure arm solenoid to
confirm that the positioning roller assembly and the pressure arm
move up and down correctly.
6) After re-assembling the duplex unit, adjust the jogger fence width
so that the distance between both side fences become 1mm
wider than the paper size, when paper is set on the duplex tray.
(
SP adjustment mode – PAGE 10.)
1
FSM
[A]
5-119
[B]
[C]
[D]
[E]
A095/A096/A097
[F]
Advertisement
Table of Contents
