Table of Contents
Advertisement
- Front Helical Wheel -
[G]
[C]
[E]
[B]
1. Place the bearing [A] on the notch [B] on the bottom plate then set timing
belt-918XL [C] and timing belt-300XL [D] around the pulley.
2. Set the pulley [E] on the bearing. The direction of the pulley should be as
shown in the illustration.
3. Slide the wheel sensor actuator [F] onto the helical wheel. Leave the
Allen screw [G] loosened.
4. Set the helical wheel [H] in the pulley [E]. Leave the Allen screws [I]
loosened.
5. Set the bracket with a bushing [J] on top of the helical wheels then install
and slightly tighten the four screws [K].
6. Place a 0.4 mm thickness gauge [L] between the helical wheel and the
bushing on the bracket. While holding the bushing down to the helical
wheel [H], tighten the four screws [K].
7. Hook tension springs [M] and [N] then tighten the screw [O].
8. Install the wheel sensor bracket [P].
A095/A096/A097
[F]
[H]
[O]
[A]
[D]
[N]
[I]
[J]
[K]
[H]
[L]
[P]
8-32
[K]
[M]
[I]
FSM
Advertisement
Table of Contents
