Table of Contents
Advertisement
CUSTOMER SERVICE GROUP
BULLETIN NUMBER:
APPLICABLE MODEL: FT6645/6655/6665
SUBJECT: PARTS CATALOG UPDATES
GENERAL:
The following Parts Updates are being issued for all FT6645/6655/6665 Parts Catalogs. This information
should be incorporated into all existing Parts Catalog documentation.
• •
UPDATE NO. 1 -
Important:
Due to a change of vendors, the old type parts are no longer available as service parts. Please replace
these parts as a set.
New Stud
INTERCHANGEABILITY CHART:
OLD and NEW parts can be used in both OLD and
0
NEW machines.
NEW parts can be used in OLD and NEW machines.
1
OLD parts CAN NOT be used in NEW machines.
Must be installed as a set on units manufactured prior to the S/N cut-in. On units manufactured aft
3/S
previously modified, use the new part numbers individually.
TECHNICAL SERVICE BULLETIN
6645/6655/6665 - 058
OPERATION PANEL ASSEMBLY, etc.. - To meet CE Mark Standards, the Key
Board PCB has been changed. The grounding wires have been incorporated
into the new type board and the keytop sheets have been changed. Also, to
increase the durability of the Start Key, the design has been changed so that the
Key Board will not receive excessive pressure when the Start Key is pressed as
shown in the illustration below. Accordingly, the Start Key, the Operation Panel
Case, and the Key Board have been changed.
New
Start key
Start key
Old
NEW parts CAN NOT be used in OLD machines.
2
OLD parts can be used in OLD and NEW machines.
OLD parts CAN NOT be used in NEW machines.
3
NEW parts CAN NOT be used in OLD machines.
06/04/96
Existing Studs
Operation Panel Case
Key Board
er the S/N cut-in or
Continued...
Advertisement
Table of Contents
