Table of Contents
Advertisement
10
MEMORY CLEAR
PAGE 1
Clear
Item
Returns all data to the default data.
* This step exists to eliminate clearing the data in RAM by mistake.
Counter clear (SC counter, PM counter, copy counter etc.) does not require
the front door to be opened.
NOTE: After clearing all memory, perform at least the following.
1. Perform the process data initial setting.
2. Install new developer and then perform the Toner Density sensor
(Developer) initial setting.
3. Input the Lens Error Correction data (SP Adjustment page 5: refer to
page 4-11 of the service manual).
For the other items, basically the default data is acceptable. Check the copy
performance and copy image and adjust copy image or timing if necessary.
FSM
Function
4-35
Note
Procedure to clear:
1. Open the front door*.
2. Touch .
The display changes as shown at
right.
3. Touch
.
Yes
Clear
(Touch
to cancel.)
No
The display returns to the one
shown at left and the beeper
sounds twice.
4. Turn the main switch off and on.
A095/A096/A097
Rev. 8/02/94
Advertisement
Table of Contents
