Table of Contents
Advertisement
24. Install the shutter inner cover [A] (1 screw).
25. Push the lever [B], to the full rear position and set the shutter cover [C].
26. Set a toner bottle by following the instructions on the decal.
NOTE: Before plugging in the power cord, install the guidance ROMs.
(–26, –27 machines) (See page 3-12)
27. Plug in the power cord, then turn on the main switch. The machine
automatically enter the process control data initial setting mode.
NOTE: Do not make any copy until completing developer initial setting.
Do not turn off the main switch during the process control data initial
setting mode.
28. Add paper to at least one tray.
A095/A096/A097
[A]
3-10
[C]
[B]
FSM
Advertisement
Table of Contents
