Table of Contents
Advertisement
Tech Service Bulletin No. 6645/6655/6665 - 057
Page 4 of 5
Duplex Default Mode
NOTE: There is an explanation of the Duplex mode in your Operating Instructions. The explanation of the
Duplex mode described below is a supplement/correction to that given in your Operating
Instructions.
The factory (Default) setting in Menu 5 (Set operation modes) of the User Tools has been set at "PROGRAM
5" rather than "NORMAL". This allows copy modes stored in Program 5 be set as the default. (For detail,
refer to Page 16 of your Operating Instruction Book.)
To save paper resources, the following Duplex mode has been selected as the factory (default) setting using
Program 5:
• Copiers with the document feeder and the sorter stapler are set for two sided copies from an even
number of originals.
• Copiers with the recirculating document handler and the finisher are set for two sided copies from one
sided originals.
Canceling The Duplex Default Mode
To cancel the Duplex Default mode, store one-sided copy mode in Program 5 as follows:
1. Press the Clear Modes key.
2. Touch the [Duplex/Series Copies] key to cancel the duplex
mode.
Note: The illustration on the right shows the display for
the document feeder and the sorter stapler system.
3. Press the Program key.
4. Touch the [Store Program] key.
5. Touch the [5] key.
Then, the display shows "Program 5 has been stored. Do you
want to revise the program?".
6. Touch the [Yes] key to overwrite a new program.
7. Touch the [5] key again to enter a new program.
4
5
Continued...
Advertisement
Table of Contents
