Table of Contents
Advertisement
6.6.2 Paper Feed Timing Adjustment FT6665 (A097) Only
[B]
10 mm
[D]
10 ± 5 mm
1-1) Paper feed timing adjustment for the 1st, 2nd, 3rd feed stations,
the
LCT and duplex unit (A097 copier)
1. Place a sheet of white paper on the exposure glass so that there is a gap
of 10 mm between the white paper [A] and the left scale [B].
2. Enter SP mode (refer to Service Program Access Procedure) and access
the SP Adjustment – PAGE 2.
3. Touch the "Copy in SP" key [C] then select the 1st feed station.
4. Touch the "SP Mode" key.
5. Press the Start key and evaluate the width of the white area [D] on the
copy. The adjustment standard is 10 ± 5 mm.
NOTE: In this mode, the registration roller does not stop for registration.
Do not make copies in "Copy in SP" mode for this adjustment. In
"Copy in SP" mode, the registration clutch stops normally.
6. Touch the – key [E] or the + key [F] to adjust the white area width.
7. Repeat steps 5 to 6.
NOTE: Adjustment procedure for the 2nd, 3rd, by-pass, duplex and
large capacity trays continues on page 5-74.
FSM
[C]
[A]
[E]
A
5-74
[F]
A095/A096/A097
Advertisement
Table of Contents
