Table of Contents
Advertisement
2. The grounding spring [C] at the grounding plate [D] (this prevents excessive static
charge generated by the developer from arcing between the development unit and the
registration guide plate)
NOTE: From December 1993 production, the grounding spring inner
diameter has been reduced so that it is properly secured and
positioned by the stepped screw.
3. The grounding spring plate [A] to the development unit
Development unit
4. The ID sensor to the ID sensor board bracket via the ground strap (this prevents static
electricity from arcing between the copy paper and the ID sensor board bracket).
Pick-off Pawl shaft
Tension Spring
5. The pick-off pawl tension spring (above) has been electrically connected to the ID sensor
board bracket since the first production machines in December, 1993 (this prevents
arcing between the copy paper and the pick-off pawl shaft).
FSM
[D]
[C]
[A]
Ground Strap
ID Sensor Board Bracket
6-39
Rev. 4/4/94
A095/A096/A097
Advertisement
Table of Contents
