Copier Feed Unit Removal - Ricoh A095 Service Manual

6.15 COPIER FEED UNIT REMOVAL

[A]
1. Remove the development unit. (Refer to Development Unit Removal.)
2. Remove the right inner cover. (Refer to Right Inner Cover Removal.)
3. Remove the by-pass feed motor. (Refer to By-pass Feed Clutch
Removal.)
4. Remove the three connectors [A] for the guide plate positioning solenoid,
registration clutch, and the pick-up solenoid.
NOTE: Before disconnecting the connectors, make sure to identify
them. Some of the connectors use identical pin leads but they
are not interchangeable. Take special care not to misconnect
the positioning solenoid and registration clutch connectors.
5. Remove the upper right cover [B] and the paper feed unit cover [C].
6. Disconnect the three connectors [D].
7. Draw out the duplex unit about 10 cm.
FSM 5-89
[D]
[B]
[C]
A095/A096/A097