Table of Contents
Advertisement
6.4 TANDEM REAR FENCE DRIVE BELT REMOVAL
(A096/A097 copier only)
[E]
1. Draw out the tandem tray.
2. Separate the right tandem tray from the left tandem tray [A]. (Refer to
Tandem Tray Removal.)
3. Remove the rear fence [B] on the left tandem tray (2 screws).
4. Remove the rear base plate [C] with the rear fence drive motor [D] (3
screws).
NOTE: When re-installing the rear base plate, make sure that the
grounding plate [E] is attacked to the rear base plate.
5. Remove the end fence [F] (2 screws).
6. Remove the center bottom plate [G] (2 screws).
A095/A096/A097
[D]
[C]
[F]
5-70
[B]
[C]
[A]
[G]
FSM
Advertisement
Table of Contents
