Inverter Solenoid Removal And Adjustment - Ricoh A095 Service Manual

6.5

INVERTER SOLENOID REMOVAL AND ADJUSTMENT

[B]
1. Remove the feed-out unit. (Refer to Feed-out Motor Removal.)
2. Remove the inverter solenoid [A] (2 screws).
NOTE: When installing the inverter solenoid, confirm the following:
1) The arm [B] must be set on the plunger pin [C].
2) Manually pull the inverter solenoid plunger and confirm that
when the inverter solenoid does not activate (OFF), the
inverter guide [D] is inside the outer inverter guide [E] and
when the inverter solenoid activates (ON), the inverter guide
is outside the outer inverter guide, as shown.
FSM
[C]
[A]
[D]
[E]
ON
OFF
7-21
OFF ON
A095/A096/A097