Registration Clutch Removal - Ricoh A095 Service Manual

6.12 REGISTRATION CLUTCH REMOVAL

[B]
[C]
[D]
[A]
[E]
[F]
1. Lower then unhook the main control board bracket hinge. (Refer to
By-Pass Feed Clutch Removal.)
2. Remove the clutch stopper [A] (1 screw).
NOTE: When re-installing the registration clutch [B], set the pin [C] of
the clutch in the cutout of the stopper [D].
3. Loosen the Allen screw [E].
4. Remove the registration clutch (1 connector).
NOTE: When re-installing the registration clutch, fully push in the clutch
on the registration roller shaft [F] and secure the Allen screw.
A095/A096/A097 5-86 FSM