Pick-Off Pawl Replacement - Ricoh A095 Service Manual

4.7 PICK-OFF PAWL REPLACEMENT

[G]
[F]
1. Remove the ID sensor board bracket [A] (2 screws).
2. Disconnect the ID sensor harness [B].
3. Remove the E-ring [C], then slide out the bushing [D] (1 screw) and collar
[E].
4. Fully slide the shaft [F] to the rear.
5. Replace the pick-off pawl [G].
NOTE: Do not forget to hook the tension spring [H].
After replacement, check that the pick-off pawls move smoothly.
FSM
[C]
[D]
[A]
[B]
[H]
5-55
Rev. 4/15/94
[H] [H]
A095/A096/A097