Ricoh A095 Service Manual page 357

[B]
3. Install the cover [A] with the screw supplied as an accessory of the
copier.
4. Install two stepped screws [B] to hook the DJF.
NOTE: There is one screw hole available on the left side for one of the
stepped screws. However there are two screw holes available
on the right where the stepped screw is to be installed. Install the
stepped screw into the inner screw hole [C] as shown in the
illustration.
5. Mount the DJF to the two stepped screws [B] by aligning the holes in the
DJF hinge [D] and the stepped screws, then slide the DJF to the front as
shown.
6. Secure the DJF to the copier (2 screws - M 5 x 10).
7. Remove a small cap on the upper rear cover of the copier then connect
the connector [E] and the fiber optic cable connector [F].
CAUTION: Locate the fiber optic cable [F] over the electrical cable[E]
so as not to bend the fiber optic cable[F] while opening
and closing the DJF.
A095/A096/A097
[B]
[A]
[D]
[B]
7-8
[B]
[C]
[E]
[F]
FSM