Table of Contents
Advertisement
Rev. 4/4/94
Spring replacement procedure
[B]
[A]
[C]
[D]
1) Remove the ID sensor Bracket [C] (2 screws).
2) Remove the old tension spring (1 E-ring).
3) Install the new tension spring (1 E-ring)
4) Re-install the ID sensor board bracket. Secure the hook [D] at the
end of the spring to the screw fixing the ID sensor board bracket.
6. Ensure the main charge corona is set properly and is secured to the drum
stay with a screw (this prevents poor contact at the rear terminal which could
result in high voltage leakage).
7. The anti-static brush [A] must be in contact with the edge of the fusing
roller (this prevents static from accumulating on the fusing roller and arcing
to nearby metal parts).
[A]
Fusing Unit
A095/A096/A097
6-40
FSM
Advertisement
Table of Contents
