Seat Installation - Factory Five Racing Mk3 Roadster Assembly Manual

Table of Contents

Advertisement

Use a couple of the small insulated line clips, with screws or rivets, to hold it to the trunk lid to hold
the wires.
2. Pass the two wires from the License plate light through into the trunk.
3. Insert the rear license plate lamp into the trunk holes drilled earlier. Attach the washers and the nuts
to the backside of the body. The lamp comes with nuts for the bolt mounts.
4. Connect the wires to the light.
5. Drill two
/
" holes through the license plate bracket and the trunk.
3
16
6. Use two
/
" rivets to attach the bracket to the trunk.
3
16
7. Put a small section (5"- 6" long) of adhesive backed foam (included with kit) on back lower edge of a
license plate.
8. Attach the license plate to the mount using self-tapping screws provided with the kit.
ATTENTION: This kit is only a collection of parts designed for use primarily as a race car. Applying
the license plate bracket does not mean that this vehicle is street legal. Factory Five Racing
does not build completed or partially completed street vehicles. If you choose to title, register
and operate your kit on public roads, you are responsible for ensuring that the vehicle you build
complies with all Federal, Sate and local laws regarding its use. The inclusion of the license
plate bracket does not indicate that this kit complies in any way with local, State or Federal laws.
TOOLS: 8mm socket, drill,
PARTS: Black Vinyl seats (FFR# 13939).
1. The seats are mounted in four places through the base into the frame. The frame points that can be
used are: The 4" round tube, the rear 2"x 2" outrigger, the

Seat Installation

/
" and
/
" drill bits, marker, ruler, silicone, and caulk gun.
13
9
64
32
172
www.factoryfive.com
/
" mount plates or, a ¾" tube.
1
16
508-291-3443

Advertisement

Table of Contents
loading

Table of Contents