Gsm Options - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
10.6.10. Telecontrol/Vocal Message Timeout
The Telecontrol/Vocal Message Timeout (TC/VM Timeout) determines the duration of a
Telecontrol, Two‐Way Audio or Vocal Message call. In the case of a Telecontrol or Two‐Way Audio
call, when the time out expires, the system automatically disconnects unless the call is manually
extended by the operator. For Vocal Message calls, if the time out expires and the user has not
acknowledged the message, the system attempts to call the next Voice Report account's telephone
number. During a Vocal Message call, the timeout is reset each time a message is acknowledged.
To program the Telecontrol/Vocal Message Timeout:
1. From the Programming menu, select Communications, Comm. Options, and TC/VM
Timeout [95411].
2. Enter a time (001‐255 seconds), and then press ʹ√ʹ.
10.6.11. TWA Mode
The Two‐Way audio features offer a choice of two operation modes:

Duplex – both parties may speak at once just like a regular telephone.

Simplex – one party may speak while the other party listens.
To program the TWA mode option:
1. From the Programming menu, select Communications, Comm. Options, and TWA Mode
[95412].
2. Select Duplex or Simplex.
10.7.

GSM Options

10.7.1. GSM RX Report
The GSM RX Report is a feature that periodically reads the GSM signal strength of the Cellular
Communication – see p.31, 4.7.9 GSM Signal Strength. This reading occurs at the times programmed
for the Periodic Test – see p. 68, 10.6.2 Periodic Test Interval, and p. 68, 10.6.3 First Test. This means
that each time the periodic test is sent, the system also sends a GSM signal strength report to the
central station. The system also enters the GSM signal strength in the event log.
If the Periodic Test is disabled, the GSM RX Report feature will not function. The GSM RX
report belongs to the Peripherals event group – see p. 74, 10.9 Event Options for Central
Station Reporting. If this event group is disabled, the GSM signal strength is still recorded in
the event log.
To program the GSM RX Report option:
1. From the Programming menu, select Communications, Comm. Options, GSM Options,
and GSM RX Report [954131].
2. Select Enabled or Disabled.
70
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.
CommPact Installation Manual