Event Options For Central Station Reporting - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
10.9.

Event Options for Central Station Reporting

System events are divided into a number of different event groups. This division allows you to
enable or disable reporting or Two‐Way Audio for a specific group of events.
The different event groups are as follows:

Burglary [#1]

Fire [#2]

Open/Close (arm/disarm) [#3]

Service [#4]

Power [#5]

Peripherals [#6]

RF Jamming [#7]

Medical [#8]
10.9.1. Event Reporting
You can enable or disable event reporting per Event Group. This allows you to filter the type of
events that are reported to the central station.
To enable/disable reporting for an event group:
1. From the Programming menu, select Communications, Event Options [955].
2. Select an Event Group.
3. From the event group's sub‐menu, select Report [#1].
4. Select Enabled or Disabled.
10.9.2. Restore Reporting
For each event group, you can determine whether restore messages will be sent.
There is no Restore for No Motion event.
To enable/disable restore reporting for an event group.
1. From the Programming menu, select Communications, Event Options [955].
2. Select an event group.
3. From the event group's sub‐menu, select Report Restore [#2].
4. Select Enabled or Disabled.
74
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.
CommPact Installation Manual