Perimeter Arming - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.
3.6.5.

Perimeter Arming

Perimeter arming is designed for when the occupant intends to remain inside the premises and
secure the perimeter.
To arm the system's perimeter using the front panel keypad or Wireless Keypad:
1. Check if the system is ready to arm.
2. Press the Perimeter arming key on the keypad.
3. If One‐Key Arming is disabled, enter your user code.
3.6.6. Combination Arming
The system allows you to activate a combination of two arming methods. If you Perimeter arm the
system, you may also activate Full or Part arming. Likewise, you can Perimeter arm the system
after activating Full or Part arming. It is not important which arming mode you choose first.
You can activate the second arming mode only during the exit delay of the first arming
mode. When the first exit delay expires, you cannot activate a second arming mode.
For combination arming, perform the following procedure:
1. Check if the system is ready to arm.
2. Activate the first arming mode.
3. If One‐Key Arming is disabled, enter your user code.
4. While the exit delay of the first arming mode is counting down, activate the second
arming mode.
5. If One‐Key Arming is disabled, enter your user code.

It is not possible to activate Full and Part arming modes simultaneously. It is
necessary to disarm first when changing from one arming mode to another arming
mode.
The exit delays of the two arming modes are entirely independent. The moment an arming mode is
activated, its exit delay begins to count down. The entry delay depends on which detector was
tripped first. For example, if the detector is included in Full arming, the entry delay for Full arming
counts down – see p.42, 7.3.2 Arm Set. If the detector is included in both activated arming modes,
the entry delay for Perimeter arming counts down.
Disarming cancels both active arming modes.
3.6.7. Disarming
When an entry/exit detector is tripped, the entry delay counts down; each arming method has its
own entry delay.
To disarm the system:

Enter a valid user code, the system is disarmed.
You can only disarm all the active arming modes.
CommPact Installation Manual
19