Electronics Line CommPact Installation Manual page 148

Arm/Disarm
Figure C- 4: Arm/Disarm Page
You can arm and disarm the system using the Arm/Disarm drop‐down box (upper‐right part of the
page) or using the buttons in the System Operation Area.
The Web Application allows you to arm and disarm your system via the Web Application using
any of the available arming methods. It is important to note that when you arm using the Web
application, the system is armed with the programmed delay.
1. On the Status Bar below on the page you can see the current status of the system (in our
example it is Disarmed and System Ready, which means that the system and all the
detectors are working properly and there are no events to report).
2. It is possible to check if there were alarms in the system – see p. 148.
System Users and Codes
In this area you can add, delete, or change users and the User Codes for your system (for example,
add codes for family members).
1. On The Main Page menu, click Settings.
Figure C- 5: Settings Button
2. Click System Users and Codes, the following page appears:
144
Appendix C: Web User Application
CommPact Installation Manual