Electronics Line CommPact Installation Manual page 39

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.
2. Enter the Telecontrol code (Code 29) on your telephone within 15 seconds.
Do not enter your user code until you hear the two DTMF tones. Any digits entered before
the tones are sounded are disregarded by the system.
3. A DTMF tone is sounded to indicate that the system is ready to receive commands.
The following DTMF commands are available:
Press ʺ2ʺ for Two‐Way Audio.
o
If the TWA mode is defined as ʺSimplexʺ (see 70, 10.6.11, TWA Mode.), the audio
channel opens in Listen mode (microphone active/speaker mute). To switch to Speak
mode, press ʺ1ʺ on your telephone. To switch back to Listen mode, press ʺ0ʺ on your
telephone.
During the TWA session, you can adjust the speaker volume using the arrow buttons.
Press ʺ3ʺ to fully arm the system.
o
Press ʺ430ʺ to activate PGM output (Unit 30)
o
Press ʺ530ʺ to deactivate PGM output (Unit 30)
o
Press ʺ6ʺ to disarm the system.
o
Press ʺ9ʺ to cancel the siren.
o
Arm/Disarm, PGM on/off, and Siren Canceling can also be executed at any time
during a Two‐Way Audio session.
Error beeps (three tones) sound in case of a wrong command.
To clear the last command, press ʺ*ʺ or ʺ#ʺ.
The duration of the call is determined by the TC/VM Timeout ‐‐ see p.70, 10.6.10
o
Telecontrol/Vocal Message Timeout. Ten seconds before the timeout expires, two
short DTMF tones are sounded. To extend the call, press ʺ7ʺ on your telephone.
This command restarts the timeout.
4. To disconnect before the end of the timeout, press ʺ*ʺ then ʺ#ʺ on your telephone.
5.1.5. Arm/Disarm DTMF Commands
During a Telecontrol call, you can arm and disarm the system remotely using the DTMF commands
3ʺ (arm) and ʺ6ʺ (disarm). When arming the system in this way, the system is armed immediately
without an exit delay.
5.1.6. PGM DTMF commands
During a Telecontrol call, you can activate and deactivate PGM using the DTMF commands ʺ430ʺ
(PGM On) and ʺ530ʺ (PGM Off).
5.1.7. Siren Cancel ("Bell Cancel")
The siren is muted during Two‐Way Audio communication. At the end of the call, the siren is re‐
activated (if the Siren Cut‐Off has not yet expired). During the call, pressing ʺ9ʺ on your telephone
cancels the re‐activation of the siren.
5.1.8. Central Station Two-Way Audio
Central Station Two‐Way Audio is an alarm verification feature that enables the central station
operator to establish Two‐Way Audio communication with the Control System within ten minutes
of an alarm.
CommPact Installation Manual
35