Message Center - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.
4.7.2.

Message Center

The CommPact Control System Message Center is designed to allow the user to record a short
message that may be played back later by another user. After a message is recorded, Message
Waiting is displayed on the LCD until the message is played back. If the Vocal Message option is
enabled, the Message Waiting vocal message is sounded.
Recording a new message automatically overwrites the previous messages in the Message
Center.
To play back a recorded message:

From the Service menu, select Messages, Play Message [7021].
To record a message:
1. From the Service menu, select Messages, Record Message [7022].
2. Press ʹ√ʹ to start recording the message.
3. Record your message. The message may be up to twenty seconds long.
Time left out of the 20 secondsʹ timeout is displayed on the LCD.
4. Press ʹ√ʹ to stop recording; the message is automatically played back and OK? Is
displayed.
5. Press ʹ√ʹ to save your recording.
To delete a message:
1. From the Service menu, select Messages, Delete Message [7023]; OK? Is displayed.
2. Press ʹ√ʹ, the message is deleted.
The Record and Play options can also be accessed via a convenient shortcut without needing to
enter a valid user code.
To play back a recorded message via a keypad shortcut:

From Standby mode, press
To record a message via a keypad shortcut:

From Standby mode, press
4.7.3. Wireless Siren Test
To test the wireless siren:

From the Service menu, select WL Siren Test [703]; the external siren is sounded
briefly.
4.7.4. Siren Test
To test the Control System's Built‐In Siren:

From the Service menu, select Siren Test [704]; the Control System's Built‐In Siren is
sounded briefly.
4.7.5. Interface Test
The Interface test enables you to check if the speaker, LEDs and LCD are functioning correctly.
To test the system interface:

From the Service menu, select Interface Test [705]; a short sequence of chimes are
sounded from the speaker, all LEDs flash and the LCD Display is tested.
CommPact Installation Manual
then ʹ√ʹ.

, 'Χ'then ʹ√ʹ.

29