Call Timeout - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.

10.6.5. Call Timeout

The Call Timeout is the amount of time the system waits for the first acknowledgement (ACK1)
from the central station when reporting using the PSTN. If ACK1 is not received during this time,
the system regards the call as a failed dialing attempt.
To program the Call Timeout:
1. From the Programming menu, select Communications, Comm. Options, and Call
Timeout [95405].
2. Enter a time (001‐255 seconds), and then press ʹ√ʹ.
10.6.6. ACK. Timeout
The ACK Timeout is the amount of time the system waits for the second acknowledgement (ACK2)
from the central station when reporting using the PSTN. If ACK2 is not received during this time,
the system regards the call as a failed dialing attempt.
To program the ACK Timeout:
1. From the Programming menu, select Communications, Comm. Options, and ACK
Timeout [95406].
2. Enter a time (001‐255 seconds), and then press ʹ√ʹ.
10.6.7. PSTN Country
In order to meet the requirements of local telecommunications authorities, default telephone line
parameters have been chosen for a number of different countries.
To program the PSTN Country:
1. From the Programming menu, select Communications, Comm. Options, and PSTN
Country [95407].
2. Select your country from the options available.
Electronics Line 3000 offers custom telephone line parameter settings for countries that do
not appear in the list of pre‐defined options. If your country does not appear among the
available options, select the option Custom Settings.
10.6.8. Dial Tone Wait
This option determines whether the system dials only when the dial tone is present or if the dialing
is initiated regardless of the dial tone.
To program the Dial Tone Wait option:
1. From the Programming menu, select Communications, Comm. Options, and Dial Tone
Wait [95408].
2. Select Enabled or Disabled.
10.6.9. Incoming Calls
This option determines whether the Control System is able to receive incoming Telecontrol/Two‐
Way Audio calls.
To program the Incoming Calls option:
1. From the Programming menu, select Communications, Comm. Options, and Incoming
Call [95410].
2. Select Enabled or Disabled.
CommPact Installation Manual
69